Foglights Part 2.
Of course, this is not very similar to foglights, rather like a working dipped beam.
It's been 10 months since my last oil change! The car has traveled 4500 km! This time I used a comb to pump out the oil! — Unscrewed the oil filter by putting a disposable cup on it — so that the remaining oil would merge into it! — the result is not a single drop spilled! Everyone ✌️!
Fuel flap drive
Finally got around to finishing the process of replacing the cable with an electric drive.
As part of the autumn maintenance:
DIY repair, soldering
Revision of the front calipers.
After buying a car for your peace of mind and confidence that the caliper will not jam. Decided to make an audit. I disassembled and the guides were already on the verge and did not work for sure - I cleaned it - I replaced the grease in the guides - I cleaned out a little rust on the calipers and painted it with heat-resistant paint. Decided to move away from the tradition of painting in red painted in black.
Help with the situation
1-When I was driving back from Tyumen, I began to hear the rustling sound of the bearing when I pressed the gas at a speed of 80-100, I made a mistake on the outboard cardan shaft, but then I read the post-topic www.drive2.ru/l/627663635…age=0#a627707341080367311
Factory wiring for fog lights
We are talking about factory wiring on PTF for Rav-4 in the first body until 1998.
Toyota RAV4 Roof Leak Repair
Hello! On hot summer days, I decided to fix the problem of roof leakage on the ceiling lining.
Replacement of the bearing of a secondary shaft of a variator
There was a rumble while driving 80-120, then it is not audible, apparently because of the noise. Moreover, when the accelerator pedal is released, the howl stops. I found a report about this on this resource: